power setting 64 bit drivers download - X 64-bit Download

... Added switchdev suppot - Added support for higher power modules on select Intel Ethernet Network Adapters. Intel ... ports if the link is not connected at power on. - Linux Driver: Ethtool was incorrectly reporting ...

... a VF is attached to a VM, avoid setting the MTU value of the VF within the ... issue where the FW was trying to get power consumer parameters on a module that was not ...

... by the iavf driver and will be ignored. Setting [tx|rx]-frames-irq using ethtool -C may not correctly save the intended setting and may reset the value back to the default value of 0. - LinuxDriver: Interrupt Moderation settings reset to default when the queue settings of ...

... by the iavf driver and will be ignored. Setting [tx|rx]-frames-irq using ethtool -C may not correctly save the intended setting and may reset the value back to the ... of 0. - Linux Driver: Interrupt Moderation settings reset to default when the queue settings of ...

... by the iavf driver and will be ignored. Setting [tx|rx]-frames-irq using ethtool -C may not correctly save the intended setting and may reset the value back to the ... of 0. - Linux Driver: Interrupt Moderation settings reset to default when the queue settings of ...

... 256 transmit/receive queue pairs The following Microsoft PowerShell cmdlets now support Intel Ethernet 700 Series devices: ... - Reset-IntelEthernetLogConfig - Disable-IntelEthernetLogConfig The following Microsoft PowerShell cmdlets now support "Driver" as a valid value ...

... - General: Empire Flats (E810CQDA2OCPV3G and L) MultiPort power class limits to 3.5W should only be present ... in all CVL4.5 and later builds. The module’s power requirements exceed the device’s power supply. - ...

... used for saving and restoring firmware and BIOS settings to a binary/INI file, and for configuring firmware and BIOS settings through a command-line interface.Change List:- Build 21: Add "/gpc" to support graceful power cycle - Build 21: Add deb package for ...

... used for saving and restoring firmware and BIOS settings to a binary/INI file, and for configuring firmware and BIOS settings through a command-line interface.Change List:- Build 24: Support Fan UCC, Air Flow Limit, Exit Air Temp settings and display - Build 23: Rebuild for Windows ...

... used for saving and restoring Firmware and BIOS settings to a binary/INI file, and for configuring Firmware and BIOS settings through a command-line interface.& UEFI_14_0 supports the following ... failure issue.& - Build 25: Support LAN failover setting on specific NIC& - Build 25: Support new ...